Powder selection 300 whisper Saeco 301

  • 367 Views
  • Last Post 07 August 2018
Richard Pickering posted this 31 July 2018

Recently I adopted a SSK 300W 10'' Barrel. It is a 1 in 8 twist. I have an RCBS 165 Sil and a Saeco 301. I'd like opinions on powder selection. I'd like to use 4198 in these. I'd also like to hold MV to around 1300fps using the Rcbs and 1100 to 1150 using the Saeco. Suggestions ? 

Attached Files

Order By: Standard | Newest | Votes
Scearcy posted this 01 August 2018

2400 was a very good low velocity powder for me with the 300 BLK (same as whisper) and 4227 was the best for full power although it might not work well in a 10" barrel. Frankly I believe you will be better of with faster rather than slower powders. 4198 smoked cases for me even in a rifle. You might be surprised how easy Tite group would be to work with. Unique certainly will work well - it did for me. Good luck it is a great cast bullet cartridge.

There was a three article series on the 300 BLK in TFS a couple of years ago. They are a bit dated now as I did much of the testing before reloading manuals included the 300 BLK but there is still some good info.

Jim

Attached Files

Richard Pickering posted this 02 August 2018

 Jim, Presently I have no 2400.  I do have 4227 and have used it in 32-20 with the RCBS 165 and Saeco 311. I dont have experience with Tite Group. In the TC I wont be restricted to deep seating bullets as when loading for an AR. Thank you. 

Attached Files

JSH posted this 02 August 2018

Richard, I played with the 30x221 and the 30-20 some years back when it was "the" thing. Shot them both side by side, 10" factory TC barrels, both 1-10 twist.

There is not enough difference in them to argue over. I pretty much played with every powder out there. I ended up with AA9 and still use it today. Have been told formula has changed.

As mentioned, I also think 4198 will be on the slow side. I would think maybe in the line of CFE BLK, it shows on MOST burn charts to be just a bit faster than 4198. Good luck. Jeff

Attached Files

Scearcy posted this 02 August 2018

Richard

I was not shooting an AR. All 3 of my rifles are bolt guns. 4198 will be too slow. The suggestion of AA#9 was a good one too.

Jim

Attached Files

gemihur posted this 06 August 2018

Slow can be fun too.

Try Trail Boss.

It's a hoot to shoot.

http://www.300blktalk.com/viewtopic.php?t=84776

I shoot, therefore I am

Attached Files

Richard Pickering posted this 06 August 2018

Jim,   I have some Accurate 9 but I wonder about its continued availability.  RP

Attached Files

Richard Pickering posted this 06 August 2018

Thank you, but I'm not so sure TB will generate the 1050 MV I believe will be required for 200m effectiveness on Ram Silhouettes. RP

Attached Files

Geargnasher posted this 07 August 2018

Any medium shotgun/pistol flake powder will do what you want in the bolt guns.

Attached Files

Richard Pickering posted this 07 August 2018

I'd agree, but the application is for a Contender handgun. Thanks. Richard

Attached Files

beltfed posted this 07 August 2018

Another thought:  Load data for the 30 Herrett, may be close enough to the 300 BO

--starting loads

beltfed/arnie

Attached Files

Close