ARTICLES NEEDED

  • 161 Views
  • Last Post 16 March 2019
joeb33050 posted this 16 March 2019

We need articles to go on the "CAST BULLET INFORMATION" Yahoo group.

One or more on COATED/ING BULLETS.

Gary's "BORE POLISHING"

??

Thanks;

joe b.

 

Attached Files

Order By: Standard | Newest | Votes
R. Dupraz posted this 16 March 2019

My articles will go in the "Fouling Shot"

R. 

Attached Files

onondaga posted this 16 March 2019

Hi Joe!

Your prime argument against my polishing method* was that copper sticks to bores that are too shiny. You defended that well, and I believe you are right about that. However, the Pumice and Kaolin clay abrasives in Turtle Wax Chrome Polish and Rust Remover don't do that with the prescribed amount of pulls through. 47K views of the post and it's lengthy discussion haven't left any questions unaddressed. A simple link to the post has been effective in spreading the use of the method and it's acceptance. The method works to give a finer finish than production finishes by a small degree and that makes maintenance easier and copper not stick while improving cast bullet accuracy by a small percentage. That was my goal in developing the method, that, and selecting materials that are readily available and inexpensive. The BoreSnake and TWCP aren't expensive and they are easy to find. Just "make no substitutions and take no shortcuts" has been my recommendation and stick with that for full effect of the method. It is not difficult.

*original post:

https://www.castbulletassoc.org/thread/8364-my-bore-polish-method-to-shoot-better/

 

Gary

Attached Files

  • Liked by
  • Ross Smith
joeb33050 posted this 16 March 2019

It's up, thanks Gary

Attached Files

Close