Over the years I have bought a number of LEE molds. Up until they changed their mold block design, I never had an issue. The first of the new mold block design I had the pin that holds one of the mold blocks to the handle fall out, the second one had the alignment pins fall out. After that I had been vocal about not buying their molds again. I guess the passing of time makes me forgetful. After deciding to buy a .380 Auto (which I will pick up on Saturday) I thought I'd get a jumpstart & buy LEEs 356-95-RF. What the heck, the molds are cheap & if they drop a little small, I'll add a little tin to the mix. I've done it before. Well, I ordered the mold from Midway and have since received it. At first glance I said “Oh-Oh"! The mold halves were slightly misaligned. I tried casting with it anyway. The bullets are dropping .354” x .310". Yep, consistently!! I mean . . . what???!!! There isn't all the beagling or sizing in the world to fix that!! I have a number of pieces of LEE reloading equipment & swear by them but their molds suck! But . . . it's my fault . . . I knew better. Pat
If someone else had of done to me what I did to myself . . . I'd have killed him. Humility is an asset. Heh - heh.