As I under stand it, when you taper bump you make your bullet fit what part of the throat? and what part of the bullet is swaged larger? In my Ardito, there is a .536 straight freebore of .3105, and a short leade to the rifling. From what I can tell, the bullet touches the chamber throat on the driving bands only and the forward part of the bore rider bullet never touches till the rifling is reached upon firing. Maybe this bullet should be fully breach seated.
I don't get it
- 264 Views
- Last Post 28 September 2018
- Topic Is Solved
Your throat does not have a taper cut. It has a long free bore cut designed for LBT long bearing surface bullets. Veral believed in cutting longer free bore with his non tapered bullets, but cutting only .0005-.001 larger than groove diameter. You could try one of LBT's longer bullets or a bore rider with longer bearing surface to fill up free bore. I am sure Ardito experimented a lot with different designs and velocities.
I would first try a bore rider with long bearing surface something like this. Size bullet for a close slip fit in free bore and seat bullet in case very long griped at gas check area. Fitting bullet is the hardest part...maybe bore ride section fits...you want a slip fit there to. I can send you a few to try.
Pat may have some of the longer LBT designs you could try. Fitting those would be much easier and probably more accurate?
Attached Files
Sounds great. I just cast, gc'ed and lub-sized some xcb's from noe. They are a little short but might work well in the 14"twist. I have several bore riding molds, but the only hope for them would be if I can get the ogive into the rifling.
So people that bump their bullets have a shorter throat and are getting the fore part of the bullet to fit the tapered part of the throat?
Attached Files
You really need to fill up the empty free bore area to get Max support of bullet. Seat the xcb bullet long and it may shoot, but I doubt it will accurately.
Attached Files
Categories
- All Categories
- General Polls
- Contact Us w/ Forum Issues
- Welcome to The Cast Bullet Association Forum
- General
- Bullet Casting
-
Guns and Shooting
- AR Platform
- TC Contenders & Other Single Shot Handguns
- Shotguns
- Informal Matches & Other Shooting Events
- Gunsmithing Tips
- Gun Cleaning & Maintenance
- Optics
- Benchrest Cast Bullet Shooting
- Military Bench Rest Cast Bullet Shooting
- Silhouette Shooting
- Postal Match Cast Bullet Shooting
- Factory Guns
- Black Powder Cartridge
- Hand Guns
- Lever Guns
- Single Shot Rifles
- Bolt Action Rifles
- Military Surplus Rifles
- Plinkers Hollow
- Muzzleloaders
- Hunting
- Reloading
- Buy, Sell or Trade
- Other Information & Reference
Search
This Weeks High Earners
- John Carlson 22
- Bud Hyett 21
- linoww 17
- MP1886 13
- MarkinEllensburg 10
- drone 9
- Aaron 7
- beltfed 6
- Lucky1 6
- Eutectic 6